Adjustments; Adjustment Of The Opening Range - probst FTZ-I Translation Of Original Operating Instructions

Adjustments

FTZ-I
V1
6 Adjustments

6.1 Adjustment of the opening range

Before the product can be lifted and transported, the gripping range has to be adjusted to the
dimensions of the product.
● The adjustment of the gripping range may never take place on both sides at the same time.
Always adjust the gripping range first to the one and then on the other side.
Attention
● Pull the spring bolt upwards, rotate around 180° and lock in position (in nick).
● Move the rectangular tube, until the gripping range is approx. 5 cm larger than the product.
● Pull the spring bolt back up again and rotate around 180°.
● Move the rectangular tube so long until the spring bolt engages in one of the holes.
● The adjustment of the gripping range has to follow general symmetrical.
That means, it must be used in each case the same adjustable hole with both rectangular
Attention
tubes.
● Caution while adjusting of the gripping range.
Danger
There is a danger of injuring the hands!
Top view from down
Spring bolt
Rectangle tube
12/01/10
14 / 20