Table of Contents
Advertisement
Maintenance and care
FTZ-I
V1
8.2 Removing errors
ERROR
The clamping-power is not big
enough, the load is slipping
out
(optional)
(optional)
(Adjustment of the opening width)
(optional)
Unbalanced load
(Adjustment of the opening width)
(optional)
Automatic release does not
work
mechanical
(optional)
8.3 Repairs
●
Only persons with the appropriate knowledge
and ability are allowed to repair the device
CAUSE
•
The grippers are worn
•
The maximum load is exceed
•
The actual opening width is
not correct
•
The device is not loaded
symmetrically
•
The adjustment of the opening
width is not symmetrical.
•
Automatic release does not
work
●
•
Replace the grippers
•
Reduce the weight of. the load
•
Adjust the opening width
according to the load you want
to transport
•
Adjust the position of the load
•
Correct the adjustment of the
opening width
•
Clean automatic release with
high pressure-cleaner
•
Oil the automatic release
(never with grease)
•
Change the inset of the
automatic release
Before the device is used again, it has to be
checked by an expert.
12/01/10
18 / 20
REPAIR
Advertisement
Table of Contents
