Adjustments; Adjustment Of The Gripping Range - probst TSZ-MAXI Operating Instructions Manual

Adjustments

5 Adjustments
5.1

Adjustment of the gripping range

Before the product can be lifted and transported, the gripping range has to be adjusted to the dimensions
of the product.
Caution while adjusting of the gripping range. There is danger of injuring the hands!
Use safety gloves.
The adjustment of the gripping range may never take place on both sides at
the same time. Always adjust the gripping range first on the one side and
then on the other.
Pull the spring bolt (A) upwards, rotate around 180° and lock in the notch.
Move the rectangular tube (B), until the gripping range is ~5 cm (2") larger
than the gripping good.
Pull the spring bolt (A) upwards again and rotate around 180°.
Push the rectangular tube (B) back and forth, until the spring bolt (A)
engages in one of the holes.
The adjustment of the gripping range has to be symmetrically. That means,
in both rectangular tubes (B) the same adjustable hole has to be used.
When gripping L-stones, the gripping area must be adjusted asymmetrically. This moves the center of
gravity of the L-stone and the stone hangs horizontally when lifted.
An asymmetry of up to two adjustment holes is allowed.
5310.0364
A
A: spring bolt
B: Rectangular tube with holes for
adjustment of the opening width
V3
13 / 20
B
GB