Using the individual control
Adjusting the backrest tilt
The position below is obtained by pressing on the manual control.
Down
Up
Position QE1 et QE2
The QE1 and QE2 buttons are factory-set but cannot be modified.
To enter a new position for buttons QE1 and QE2, simply adjust
the couch to the desired position and then press and hold the QE1
(or QE2) button for 6 seconds.
This is stored once the LED located above the command bar
blinks.
The position can now be recalled by pressing once on the QE1
or QE2 button.
NB: When using the stored positions, movements can be interrupted
simply by pushing on one of the programme buttons (default, QE1,
QE2 or QE), any of the commands available on the couch.
QE1
QE2
20
User's Guide