2.
INSTALLATION
The 7705OE-HD comes with a companion rear plate that has 3 BNC connectors and 1 SC/PC (shown),
ST/PC or FC/PC optical connector. For information on mounting the rear plate and inserting the module
into the frame see section 3 of the 7700FR chapter.
HD INPUT:
There is a SC/PC (shown) ST/PC or FC/PC female connector for optical 10-bit serial
digital video signals compatible with the SMPTE 292M standard. The 7705OE-HD can
also be used in non-reclock mode with SMPTE 310M (19.4 Mb/s), SMPTE 259M (143 to
540 Mb/s) or DVB-ASI, or any other signal with bit rate less than 1.5 Gb/s. See section
5.1 for information on operating the module in non-reclock mode.
HD OUTPUT:
There are three BNC connectors with reclocked serial component video outputs,
compatible with the SMPTE 292M standard. In non-reclock mode these outputs contain
an equalized copy of the input signal.
7705OE-HD HDTV Optical to Electrical Converter, 19.4Mb/s to 1.5Gb/s
Figure 2-1: 7705OE-HD Rear Panels
Revision 1.6
7700 MultiFrame Manual
7705OE-HD - 3