3.3.
ANALOG VIDEO OUTPUTS
Number of Outputs: 2
Standards:
Connectors:
Signal Level:
DC Offset:
Return Loss:
Frequency Response: 0.8dB to 4 MHz
Differential Phase: <0.9° (<0.6° typical)
Differential Gain:
SNR:
Impedance:
3.4.
INPUT TO OUTPUT VIDEO PROCESSING DELAY
The delay between the input HD video's line 1 and the downconverted output video's line 1 is 50 lines of
the SD video.
3.5.
ELECTRICAL
Voltage:
Connector:
Power:
EMI/RFI:
3.6.
PHYSICAL
Dimensions:
Weight:
4.
STATUS LED'S
MODULE OK
SIGNAL PRESENT: This Green LED will be On when there is a supported video signal present at the
5.
USER CONTROLS
The A-2410MD is equipped with a 4 position DIP switch, located on the bottom of the unit, to allow the
user to select various down converted output formats. There is also a toggle switch and pushbutton which
are not used at this time.
NTSC or PAL (See Table 2)
2 BNC per IEC 169-8
1 V p-p nominal
0V ±0.1V
> 45 dB up to 6 MHz
<0.9% (<0.5 % typical)
>56dB to 5 MHz (shallow ramp)
75 ohm
+ 12VDC
4 pin male XLR or powered from battery Pack adapter
10 watts
Complies with FCC regulations for class A devices.
Complies with EU EMC directive.
6 " H x 6 " W x 2.25 " D
(150 mm H x 150 mm W x 60 mm D)
approx. 1.5 lbs. (0.7 Kg)
This Green LED will be On when the module powered up.
module input.
A-2410MD Monitoring Down Converter Manual
Revision 1.1
A-2410MD-5