Table of Contents
Advertisement
3.4.
TRANSITION
Transition Type: Select the type on transition you would like applied when the Transition button is
pressed. Options are Cut, Fade, Wipe 315, Wipe 270, Wipe 225, Wipe 180, Wipe 135, Wipe 90, Wipe
45 or Wipe 0. (item orders may vary). Transition effects only appear on the program output.
Transitions on the Preview Output are always Cut type performed at the end of the transition to
program. The numbers following the Wipe reference the angle of the wipe. This also indicates the
direction of the wipe. For example a wipe of 45 will start a 45 degree wipe that will progress from the
top left of the screen to the bottom right of the screen. See the diagram below for example. Arrows
indicate direction of wipe.
Transition Time: Set the time for the transition to take affect. The setting is referenced in frames.
Quick access provide from front panel Rate button.
Swap Mode: Toggle Yes/No setting for whether the program and preview channels are swapped after
a transition command is issued.
3.5.
PRESET
Presets are pre-defined setups for such things as Matte settings, Safe Area/Title display, Transition
settings and Key/Fill input. The parameters for the settings are stored based on the status of the
program bus. Therefore if you would like to set a preset that has a mask aspect of 2.35, you must first
set the mask. Then store the preset at the required address. All Recalled presets are recalled to the
Preview Bus and will not show on the program bus until the Transition button is pushed, or a GPI
trigger invokes the transition.
Recall Preset: Select from 1 to 10 to reload previously saved settings.
Store Preset: Select from 1 to 10 to save the current settings (Whatever the units preview bus is
configured for will be saved).
On Screen Menu
HD9625DSK Instruction Manual
Revision 2.1.2
Page 3-3
Advertisement
Table of Contents
