Table of Contents
Advertisement
2.
HD9625DSK HARDWARE
2.1.
REAR PANEL OVERVIEW
•
SERIAL CONTROL is an RS-422 OR RS-232 serial interface used for controlling the unit through
automation. Operational mode (422 or 232) can be set from the front panel. Pin out configurations
are supplied later in the chapter. The pin out configuration will change depending on the
operational mode selected. Default mode from the factory is RS-422.
•
REMOTE PANEL is an RS-422 serial interface used for connecting the RCP (remote control
panel) or DCP (desktop control panel). This DB9 connector will only be installed if you purchased
either of these options. Please refer to the DCP/RCP section of this manual for pin out information
for this port.
•
UPGRADE RS232 is an RS-232 serial interface used for connecting the unit to a PC for firmware
updates. Please use the straight though 9 pin serial cable supplied with your unit. Please refer to
the firmware upgrade section of this manual for pin out information for this port, and instructions on
performing a firmware upgrade.
•
USB TRANSFERS port is for future communications with the PC or other Evertz devices.
•
GPIO Connector is used to provide Preset selection commands to the DSK. Please refer to the
GPIO section of the manual for pin out and connection information. Preset information is available
in the On Screen Section of the manual.
•
ETHERNET Connector is used for automation control and firmware upgrade connections. Initial
product release does not support this option, however the firmware will be upgraded shortly to
provide user access to these functions, and as such the hardware is provided with all units.
•
HD OUTPUT PREVIEW, output BNC connector for serial component SMPTE 292M video. This is
the preview output connector that should be connected to an appropriate HD monitor. This output
is not ByPass protected. This output will provide the On Screen Menu when the option is released
from Evertz engineering. Please connect your downstream devices to the PROGRAM output
connector.
•
HD OUTPUT PROGRAM, output BNC connector for serial component SMPTE 292M video. This is
the program output connector that should be connected to an appropriate HD downstream device.
This output is ByPass protected and will pass video in the event of a power loss to the unit. Please
connect your downstream devices to the PROGRAM output connector.
HD9625DSK Hardware
Figure 2-1: HD9625DSK Rear Panel
Revision 2.1.2
HD9625DSK Instruction Manual
Page 2-1
Advertisement
Table of Contents
