Omron sysmac NY532-1 00-111 13 0 Series Hardware User Manual page 160

5 Installation
Additional Information
First execute the Initial Power ON Procedure and Initial Settings procedure before continuing
with the next step when the Panel PC is powered ON for the first time.
• Refer to 5-6 Initial Power ON on page 5-47 for Initial Power ON details.
• Refer to NY-series IPC Machine Controller Industrial Panel PC / Industrial Box PC Setup Us-
er's Manual (Cat. No. W568) for Initial Settings details.
4
Configure the UPS.
1) Connect the USB cable supplied with the UPS to the USB connector of the UPS and to the
USB connector of the Panel PC.
2) Configure the UPS using the UPS Settings Utility.
Refer to UPS Setting Utility Instruction Manual for S8BA/BU-2RWL for details.
3) Remove the USB cable between the UPS and the Panel PC.
5
Configure the Panel PC to auto-start after power loss within the BIOS settings.
• Refer to A-1-1 BIOS Overview on page A-2 for details on BIOS changes.
• Refer to A-1-5 BIOS - Boot on page A-9 for power loss BIOS details.
6
Simulate a power interruption and confirm a correct shutdown of the Panel PC.
• Start the Panel PC
• Start applications
• Create a power interruption
• Monitor the shutdown sequence and confirm a correct shutdown sequence
The UPS is connected and configured.
The Panel PC will shut down properly in case of a power supply interruption and restart automatically
when the power is restored.
Additional Information
• The default Input sensitivity setting is Standard voltage sensitivity and this is correct.
Do not set this parameter to Low voltage sensitivity. Doing so can cause a system malfunc-
tion when switching to battery mode.
• Do not use the Simple Shutdown Software because it can not Power OFF the IPC Machine
Controller.
5-46
NY-series Industrial Panel PC Hardware User's Manual (W557)