Initial Power On; Initial Power On Procedure - Omron sysmac NY532-1 00-111 13 0 Series Hardware User Manual

5-6

Initial Power ON

This section describes how to Power ON the IPC Machine Controller for the first time.
Ensure that installation and post-installation checks of the product are
performed by personnel in charge who possess a thorough understand-
ing of the machinery to be installed.
5-6-1

Initial Power ON Procedure

Use the following procedure to power ON the IPC Machine Controller for the first time.
1
Ensure the following conditions are present before applying power for the first time:
• The Panel PC is securely fastened to the mounting surface.
• The Panel PC is connected to ground.
• All connectors are securely fastened.
2
Ensure that an optional connected monitor(s) is powered ON.
3
Connect an optional keyboard and/or mouse.
• If using an OMRON Industrial Panel PC this is not required because it has touch functionali-
ty.
• Do not connect additional storage devices before the installation of the operating system
completed. Adding storage devices like a USB flash drive, an SD memory card or a PCIe
card might influence the default drive letter sequence.
4
Ensure the power supply is ON.
Precautions for Safe Use
Always check the power supply and power connections before applying power. Incorrect power
connections can damage the product or cause burning.
5
Press the power button and release within 1 second.
Refer to 3-3 Power Button on page 3-11 for the power button location.
The Panel PC starts and the PWR LED will go ON.
6
Verify the ERR LED is OFF.
The Panel PC is ON and the Operating System starts.
Additional Information
Refer to the NY-series IPC Machine Controller Industrial Panel PC / Industrial Box PC Setup
User's Manual (Cat. No. W568) for details on how to continue the setup.
NY-series Industrial Panel PC Hardware User's Manual (W557)
WARNING
5 Installation
5
5-47