Introduction; Purpose Of The Manual; Document And Software Version; Safety Symbols - Trane TR150 Programming Manual

Introduction

1 Introduction

1.1 Purpose of the Manual

This programming guide provides information for
advanced programming of the frequency converter. It
provides a complete overview of all parameters as well as
descriptions for all parameters.
The programming guide is intended for use by qualified
personnel.
Read and follow the programming guide in order to use
the frequency converter safely and professionally, and pay
particular attention to the safety instructions and general
warnings.

1.2 Document and Software Version

This manual is regularly reviewed and updated. All
suggestions for improvement are welcome. Table 1.1 shows
the document version and the corresponding software
version.
Edition Remarks
MG18B3xx Replaces MG18B2xx
Table 1.1 Document and Software Version

1.3 Safety Symbols

The following symbols are used in this document.
WARNING
Indicates a potentially hazardous situation which could
result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which could
result in minor or moderate injury. It may also be used
to alert against unsafe practices.
NOTICE
Indicates important information, including situations that
may result in damage to equipment or property.
TR150 Programming Guide

1.4 Safety Precautions

WARNING
The voltage of the frequency converter is dangerous
whenever connected to mains. Incorrect installation of
the motor, frequency converter or fieldbus could cause
death, serious personal injury or damage to the
equipment. Consequently, the instructions in this
manual, as well as national and local rules and safety
regulations, must be complied with.
Software version
2.51
BAS-SVP16A-EN - Rev. 2013-09-05
1 1
3