Table of Contents
Advertisement
Possible causes:
Solution:
• This may sometimes happen if "Stop" was pressed during the
heating portion of a cycle.
Wait to open the door until the temperature has gone down
sufficiently. This may take up to approximately 15 minutes.
TOO HOT CHECK HEATING
Message:
"TOO HOT CHECK HEATING" appears on the display.
Explanation:
The heating sensor recorded a temperature that is 2.5°C {25°) higher
than programmed.
Causes:
WATER IN CAGE
Message:
Exp la nation:
Possible causes:
Solution:
• Possible temperature probe failure or it water temperature in cage
exceeds target temperature by 2.5°C (25°F).
• Interruption in cold water supply.
• Check the heating setting and the thermostat.
• Clean cold water supply screens.
"WATER IN CAGE" appears on the display and the buzzer sounds.
This happens when there is still water in the cage at the moment
when the door may already be normally opened. Door lock stops
activated and all other machine functions are switched off.
• Happens when "Stop" is pressed and then "No" is answered to the
question "RESTART" while there is still water in the drum.
• Plugged drainage, blocked drain valve, cracked drain valve,
interruption in cold water supply or faulty thermostat.
• When the water has run out of the machine, you may continue to
operate the MKllA-20.
• Clean the drainage, consult the commercial distributor if the drain
valve is broken.
CAUTION
16009607
Except as necessary to perform a particular step in servicing a product, the
electrical power supply should ALWAYS be disconnected.
©1999 Maytag Appliances Sales Company
Section 4. Troubleshooting
4-7
Advertisement
Table of Contents
