Maytag MFS25PN Service Manual page 29

16009607
Tool "bottomed out" and
collar pushed forward
l~t/2
~
~\
Figure2-15
Figure2-16
With pulley removed collar is
shown on shaft of basket
Figure2-17
7. Remove bearing assembly bolts at the 10
o'clock, 2 o'clock, 4 o'clock, and 8 o'clock
position. See Figure 2-18.
Loosen bolts on trunnion
Figure2-18
8. Insert pilot rods into bearing bolt holes
and tighten. Pilot rods will serve as
supports when removing the bearing
assembly later.
9. Insert 4 jack bolts (M 16 - 60 bolts - with
at least 2 inches of thread) into threaded
holes in bearing assembly and tighten,
loosening the the bearing assembly from
the backplate. This will cause the basket
to move toward the rear of the machine
and touch the shell back, as well as create
a gap between the backplate and the
bearing assembly, exposing the basket
shaft. See Figure 2-19.
Use jack bolts to push
trunnion from back plate
Figure2-19
Section 2. Service Procedures
©1999 Maytag Appliances Sales Company
2-15