Table of Contents
Advertisement
INLET 1 ... INLET 6 KEYPAD
If in the initialization mode you have answered "Yes" to the question "MANUAL OVERRIDE
]_,"you can activate a water inlet valve during the washing process by pressing the
corresponding keypad. The inlet valve remains operational as long as you keep the
keypad pressed.
On the circuit diagram that is supplied with the machine you can check which type of
water (cold hard, cold soft or hot soft) corresponds with which water inlet (inlet 1, ... inlet
2, etc.)
DRAIN KEYPAD
If in the initialization mode you have answered "Yes" to the question "MANUAL OVERRIDE
]_," you can activate the drain valve by pressing the "Drain" keypad. The valve keeps
draining the water as long as you keep the keypad. The valve keeps draining the water
as long as you keep the keypad pressed.
HEATING KEYPAD
Heating
-,
f
lli.
If in the initialization mode you have answered "Yes" to the question "MANUAL OVERRIDE
l,'' you can activate the steam valve (heating contactor) by pressing the "7" keypad, if the
machine turns on the heating according to the water level (up to a temperature that is
approximately 10°C/50°F higher than the programmed temperature, approximate maxi-
mum 92°C/197.6°F).
ENTERING THE TYPE OF MACHINES
The MKllA-20 software contains standard
wash programs. In order to set up the cor-
rect values, the correct type of machine must
be entered. When the display shows "SE-
LECT" PROCESS - -" enter code 52, then the
following will be displayed:
ENTER
MACHINE
and will be waiting for the type of machine to
be entered:
SOFT-MOUNT (MFS) TYPE MACHINES 25-35 LBS
(10-16 KG)
3
For 25 lbs capacity machines
4
For 35 lbs capacity machines
SOFT-MOUNT (MFS) TYPE MACHINES 50-125 LBS
(22-55 KG)
4
For 50 lbs capacity machines
5
For 75-100 lbs capacity machines
6
For 125 lbs capacity machines
After entering the type of machines, the
standard wash programs will be stored into
the EEPROM memory.
CODE OVERVIEW
Codes Entered:
When "SELECT PROCESS - -"appears on the
display, it is possible to modify or change
programming functions by inputting 2 digit
codes.
Selection of fault announcement time
"FILL FAIL" 1-10 MIN and "HEATING FAIL"
50
5-20 MIN, if you answered "No" to
"FAULT SUPPRESSION" in the initialization
mode.
52
Standard wash programs.
60
Software version number appears on the
display after entering code 60.
62
Initialization (see section 3).
For zeroing out all cycle counters. This
can be done only if "SELECT PROCESS - -"
74
is on the display. Then "CYCLE RESET''
will appear and all counters are zeroed
out.
78
Allows "tweaking" the water level + 1-9
79
Allows ''tweaking" the temperature+ 1-9
89
Programming mode.
16009607
Section 3. Programming and Set-Up Procedures
©1999 Maytag Appliances Sales Company
3-2
Advertisement
Table of Contents
