Forward-Facing Installation; Child Fit; Lap-Shoulder Belt Installation; Method) - Britax Poplar S User Manual

Forward-Facing Installation

Child Fit

Britax strongly recommends:
• children should be secured with a harness system to
the highest weight or height specified; and
• the tether be used when installing the child seat
forward facing.
Use forward facing:
• with children who weigh 22 –
65 lbs (10 – 29.5 kg); and
• who are 49" (124.5 cm) or less
in height; and
• with harness straps in the
closest position above the
child's shoulders, parallel to
level ground; and
• when the top of the ears are
below the top of the head
restraint.
IMPORTANT:
weighing 22- 65 lbs (10 – 29.4 kg) forward-facing
except for lap belt only (Type 1) forward-facing
installation the harness pads must be stored for
children under 25 lbs (11.3 kg).
IMPORTANT:
a forward facing position, except it MUST be used for
lap belt only (Type 1) installation forward-facing under
25 lbs (11.3 kg).
IMPORTANT:
facing position.
Lap-Shoulder Belt Installation (Preferred

Method)

NOTE: The ClickTight replaces the need for a
locked/switched vehicle belt retractor. Locking/
switching the lap-shoulder belt retractor can
be done after you follow the install instructions
included herein if desired. If the lap-shoulder belt
retractor has been locked, please refer to the
us.britax.com/faqs to uninstall the child restraint
Remove the tether.
1.
a. Extend the tether
by lifting on the
tether adjuster.
b. Unhook the tether
hook from the back
of the child restraint
and place it over
the seat back.
28
Harness pads MUST be used with children
DO NOT use upper body support pillow in
Do not use the stability bar in a forward-
Ear Level
Shoulder
Level
1b