Britax Poplar S User Manual page 34

9. Pull the end of the
lower connector strap
to remove slack.
10. Close the ClickTight
over the lower anchor.
11. Ensure
both gray
ClickTight release
buttons are visible.
NOTE: If it is difficult to
close you may have
removed too much
slack.
12. Attach the tether hook
to the vehicle's tether
anchor (check the
vehicle owner's manual
for location).
13. Pull the loose tether
strap end to remove
slack and secure
excess webbing with
the elastic strap
attached.
Forward-Facing
Installation with LATCH
NOTE: Do NOT install
by this method for a
child weighing more
than 35 lbs (15.8 kg).
9 Recline indicator is completely within the green dashed
lines for forward-facing, after child is secured.
9 Child restraint cannot be moved front to back or side to side
more than
9 Lower connectors are routed through ClickTight.
9 The tether is secured and excess webbing is contained
and secured within your vehicle.
9 C ar seat base MUST be flat on vehicle seat and MUST be
parallel to vehicle seat.
NOTE: If the child restraint does not meet the above
criteria, repeat the installation steps or use a different
seating location in your vehicle.
32
1" (2.5 cm)
at the belt path.
9
10
11
12
13