Preparing The Vehicle; Assembly Of Techart Parts (Front Axle); Assembly Of Left And Right Lift Cylinders - Techart 097.200.840.009-01 Assembly Instructions Manual
Noselift system for 911 carrera 4/4s, 911 turbo, techart gtstreet/r all gt2, gt2 rs, techart gtstreet s/rs until my09 gt3/gt3 rs until my09 gt3/gt3 rs starting my10 cayman all boxster all
Table of Contents
Advertisement
2
Preparing the vehicle
Before starting work, check that the vehicle is free from defects. Use the PIWIS
i
system tester to read out all the fault memories of the individual vehicle
components and first rectify any faults displayed.
1 Raise vehicle at the factory-fitted lift support points.
2 Detach the wheels.
3
Assembly of TECHART parts (front axle)
3.1 Assembly of left and right lift cylinders
1
Detach connector for wheel carrier
plug connection. Detach plug
connection from wheel carrier and
unclip electrical lines on
suspension strut.
2
Remove support for brake
line/brake hose on wheel carrier.
Remove brake caliper from wheel
carrier and hang up in wheel well.
3
Undo suspension gear on anti-roll
bar (counter hold using open-end
wrench).
4 Detach tie rod and control arm on wheel carrier and pry off the ball joints using the
puller. When undoing the lock nuts, counter hold with Torx screwdriver on ball joint
pin.
5
Undo threaded joint connecting suspension-strut supporting mount to body (3 M8
lock nuts).
On vehicles equipped with PASM, the damper connection cable has to be
i
detached.
TECHART Version 07
ASSEMBLY INSTRUCTIONS
TECHART Noselift System
Fig. 03
Page 13 of 50
Advertisement
Table of Contents
