Assembly Of Techart Parts (Rear Axle, Only For 997 Gt3/Gt3Rs) - Techart 097.200.840.009-01 Assembly Instructions Manual
Noselift system for 911 carrera 4/4s, 911 turbo, techart gtstreet/r all gt2, gt2 rs, techart gtstreet s/rs until my09 gt3/gt3 rs until my09 gt3/gt3 rs starting my10 cayman all boxster all
Table of Contents
Advertisement
4
Assembly of TECHART parts (rear axle, only for 997 GT3/GT3RS until MY09)
1
Remove coil-over suspension
struts of rear axle and
disassemble.
2
The PU auxiliary spring (36),
adapter disk (37) and support
mounting (43) are taken over from
the vehicle.
3
Assemble the following TECHART
parts in this order: auxiliary spring
(38), intermediate ring (39), main
spring (40), adapter ring (41) and
plastic shim (42).
The coil-over suspension struts are
i
installed in reverse order.
For coil-over suspension struts with
PASM, the electrical cable is
inserted at the top through the dome
and plugged into the wiring harness.
With the 997 GT3/GT3RS from MY10
i
the built in of the rear axle spring is
not required!
TECHART Version 07
ASSEMBLY INSTRUCTIONS
TECHART Noselift System
Fig. 32
Page 32 of 50
Advertisement
Table of Contents
