Table of Contents
Advertisement
9
Final inspection
1
Perform a general function test of the vehicle.
2
Read out and erase all fault memories with the PORSCHE system tester and/or
rectify any faults.
3
Align and adjust vehicle geometry in line with the manufacturer's instructions.
4
Adjust headlamps.
5
Next, carry out a test drive, then check the fault memory again.
10
Tightening torques
Location
Brake caliper to wheel carrier
Piston rod to front axle supporting mount M 14 x 1.5
Piston rod to rear axle supporting mount
without PASM
Piston rod to rear axle supporting mount
with PASM
Control arm to ball joint
Tie rod/linkage steering to wheel carrier
Control arm – camber eccentric
Diagonal link to control arm
Suspension strut supporting mount to
body, front axle
Suspension strut supporting mount to
body, rear axle
Anti-roll-bar mount to anti-roll bar
Suspension strut to wheel carrier, front
axle
Suspension strut to wheel carrier, rear
axle
Wheel to wheel hub
Hydraulic lines
Lift cylinder banjo bolt
TECHART Version 07
ASSEMBLY INSTRUCTIONS
TECHART Noselift System
Description
M 12 x 1.5
M 12 x 1.5
M 12 x 1
M 12 x 1.5
M 12 x 1.5
M 12 x 1.5
M 14 x 1.5
M 8
M10
M 10 x 1.5
M 12 x 1.5
M 12 x 1.5
M 14 x 1.5
Union nut
M 10 x 1
Type
Tightening torque
Tightening torque
Tightening torque
Tightening torque
Tightening torque
Tightening torque
Tightening torque
Tightening torque
Tightening torque
Tightening torque
Tightening torque
Tightening torque
Tightening torque
Tightening torque
Tightening torque
Tightening torque
Basic value
85 Nm
80 Nm
60 Nm
32 Nm
75 Nm
75 Nm
100 Nm
160 Nm
33 Nm
46 Nm
46 Nm
85 Nm
110 Nm
130 Nm
15 Nm
20 Nm
Page 46 of 50
Advertisement
Table of Contents
