Table of Contents
Advertisement
2
Unscrew the threaded connection
of the hydraulic line (1200 mm)
(5).
3
Press the supplied rubber
grommet (10) into the free bracket
on the vehicle (11) and thread the
hydraulic line (1200 mm) (5)
through from above.
The picture shows the dual-sided
bracket (11) on the 997 Turbo. On
the 997 GT3, the front bracket
(viewed in the direction of travel) is
intended for the hydraulic line (1200
mm) (5).
4
Screw threaded connection onto
hydraulic line (1200 mm) (5) and
tighten.
Before the hydraulic line is finally
i
fastened in place, it is necessary to
ensure that the size of the loop is
large enough. The size of the loop
must be chosen so that it cannot be
placed under stress or kinked
throughout the entire working range
of the suspension strut.
TECHART Version 07
ASSEMBLY INSTRUCTIONS
TECHART Noselift System
Fig. 17
Fig. 18
Fig. 19
Page 22 of 50
Advertisement
Table of Contents
