Schema Pneumatico; Hoisting / Handling; Installation - Fasep RASE.2247 Instruction Manual

To remove the machine from the pallet, follow the following instructions:
Unscrew the fixing screws on machine feet.
Lift the machine sideways enough to insert the forks of the fork-lift truck between the machine and
the pallet .
This hoisting point must be used whenever you need to change the installation position of the ma-
chine.
Do not attempt to move the machine until it has been disconnected from electricity and compressed
air supply systems.
DANGER :
DURING THE MACHINE TILTING OPERATION, BE SURE TO AVOID SITUA-
TIONS OF PRECARIOUS BALANCE OR WET FLOOR.
WARNING
The installation site must be chosen in strict compliance with the relevant re-
gulations regarding safety in the workplace.
IMPORTANT: for correct, safe use of the equipment, users must ensure a lighting
level of at least 300 lux in the place of use.
CAUTION
The installation of the machine must be performed in a dry area which must
be protected from adverse weather conditions.
Install the tyre changer in the chosen work position, complying with the minimum clearances shown
in fig. 3
Place the machine so that the plug-socket combination is easily accessible.
The machine must be placed on a horizontal surface, preferably concrete of tiled floor.
Do not install on unstable or damaged surfaces.
The surface on which the machine rests must withstand the loads transmitted during operation. The
surface must have a load-carrying capacity of at least 500 Kg/m2.
Ambient working conditions
Relative humidity 50% (temp. 40°C)
90% (temp. 20°C) without condensation.
Temperature 5°C - 40°C.
WARNING
Use of the machine in a poten-
tially explosive atmosphere is
not permitted.
6

HOISTING / HANDLING

INSTALLATION CLEARANCES
700
3
800
800