Using The Whisk Attachment - BRAYER BR1254 Instruction Manual

CHOPPING
Before assembling the chopper, make sure that the
power plug is not inserted into the mains socket.
• Place the chopper bowl (9) on a flat and steady surface.
• Install the chopping knife (10) on the axis inside the
bowl (9).
ATTENTION! The blades of chopping knife (10) are very
sharp! Always hold the chopping knife (10) by the plastic
end.
• Put the products into the bowl (9).
Note: do not switch the unit on when the bowl (9) is
empty.
• Install the geared lid (8) on the bowl (9).
• Install the motor unit (2) on the geared lid (8) feeding
chute, turn the motor unit (2) clockwise until bumping,
make sure that the motor unit (2) is fixed properly.
Install the motor unit (2) evenly in vertical position (fig.
2).
• Insert the power plug into the mains socket.
• To switch the unit on, press and hold down the button
(4) .
• When you press and hold the button (4) you can
control the chopping knife (10) rotation speed by
turning the control knob (5).
• For operation at the maximal rotation speed, press and
hold down the button (3) «TURBO».
• During the unit operation hold the motor unit (2) with
one hand and the chopper bowl (9) with the other hand.
• Release the button (3 or 4) to switch off.
• After the unit operation, wait till the chopping knife (10)
completely stops rotating.
• Remove the power plug from the mains socket.
• Disconnect the motor unit (2) from the geared lid (8) by
turning the motor unit (2) counterclockwise.
• Remove the geared lid (8) from the bowl (9).
• Carefully remove the chopping knife (10) from the bowl
(9) holding it by the plastic end.
• Take the chopped products out of the bowl (9).

USING THE WHISK ATTACHMENT

• Continuous operation time should not exceed 1 minute
while using the whisk attachment (7). Make at least a
3-minute break between operation cycles.
ATTENTION! Do not use the whisk attachment (7) to
knead tight dough.
• Use the whisk attachment (7) only for beating egg
whites, making biscuit dough or for mixing ready
desserts.
Before installing the whisk attachment (7), make sure
that the power plug is not inserted into the mains
socket.
• Insert the whisk attachment (7) into the whisk gear (6).
• Insert the whisk gear (6) into the motor unit (2) and turn
it counterclockwise, make sure that the gear (6) and the
whisk (7) are fixed properly (fig. 3).
• Insert the power plug into the mains socket.
• Immerse the whisk attachment (7) into a suitable bowl
with food. You can put the foodstuffs into the cup (11).
• To switch the unit on, press and hold down the button
(4) .
EN 9