Workgroup Bridge Mode Configuration; Workgroup Bridge Mode Configuration Example - 3Com AP9152 Quick Configuration Manual

6
Workgroup Bridge Mode Configurat

Workgroup Bridge Mode Configuration Example

Network requirements
As shown in Figure
The Ethernet interface of the workgroup bridge connects to multiple hosts or printers in the wired
network, and thus the wired network is c
bridge.
The detailed requirements are as fo
The AP accesses the wired LAN, and the workgroup bridge with MAC address 000f-e2333-5510
accesses the AP
The workgroup bridge accesses the wireless service psk by passing the RSN
authentication.
Client with MAC address 0014-6c8a-43ff also accesses the wirel
Figure 6-1 Network diagram for workgroup bridge mode configuration
C onfiguration procedure
1) Select a correct country/region code
Select Advanced > Countr
country/region code, as shown in
2) Enable the client mode
Select Wireless Service > Client Mode from the navigation tree and click Connect Setup to enter the
page shown in 1).
6-1, an AP working as a workgroup bridge accesses the wireless network as a client.
llows:
as a client.
y/Region Code from the navigation tree to enter the page for setting a
Figure 3-2.
onnected to the wireless network through the workgroup
6-1
ion
(CCMP)+PSK
ess service psk.