Repeater Mode Configuration - 3Com AP9152 Quick Configuration Manual

5
Repeater Mode Configuratio
Rep eater Mode Conf
N etwork Requirements
As shown in Figure
AP1 connects to the wired network. The AP acting as a repeater needs to set up a WDS link with AP 1.
At the same time, the repeater needs to provide wireless access service for clients.
To atisfy the requirements above: s
Use the 802.11n (2.4GHz) radio to set up a WDS link between AP 1 and the repeater.
Use the 802.11n (2.4GHz) radio to connect clients to the repeater.
The channel of the
access service. In this example, channel 11 in 802.11n (2.4GHz) radio mode is used as the
working chan
Configure WDS on AP 1. For the detailed config
proc edure .
Configure WDS and access service on the repeater.
Figure 5-1 Network diagram for repeater mode configuration
AP 1
C onf guration procedure i
Perform the following configurations on the repeater:
1) Select a correct country/region code
Select Advanced > Cou
country/region code, as shown in
2) Configuring WDS
Select Wireless Service > WDS from the navigation tree to enter the WDS Setup page shown in
Figure 5-2.
iguration Example
5-1:
WDS link between AP 1 and the repeater must be the same as that of the
nel.
Channel 11
802.11n
Channel 11
Repeater
ntry/Region Code from the navigation tree to enter the page for setting a
Figure 3-2.
n
uration procedure, refer to
802.11n
Client 1
Channel 11
802.11n
Client 2
5-1
Configuration