Assembling And Installation; Delivery Set; Assembling; Power Requirements - RoboLabs VPM-RGM2 User Manual

2 Assembling and installation

2.1 Delivery set

1x Popcorn machine
1x Electric panel key
1x Cleaning brush
1x Spare halogen lamp
1x Documentation set

2.2 Assembling

1. Unpack the machine carefully.
2. Check the delivery set.
3. Remove protective film from all surfaces.
4. Wipe all surfaces with a clean soft cloth dampen with mild soap. Then remove soap residues
with a clean cloth dampen with water. Let it dry.
5. Lock all four swivel casters.
NOTE 1: Each machine is tested at the factory with corn, some amount of corn kernels might be
found inside the chamber.
NOTE 2: If equipment was stored below 0 C, keep it at normal room temperature not less than
3 hours before the first start.

2.3 Power requirements

• Power outlet MUST HAVE PROPER GROUNDING to avoid electric shock.
• If supply cord damaged, it must be replaced by manufacturer, service agent,
or skilled person in order to avoid hazard.
• Connections must be done BY SKILLED ELECTRICIAN ONLY.
Equipotential bonding wire (up to 10 sq.mm) shall be connected
• to screw terminal on the base frame marked with IEC 60417-
5021 sign:
Machine requires 5-wire 3 phase 400 VAC 50 Hz power supply. Use the 63 A 400 V 50 Hz 3+N+PE
connector in accordance with IEC 60309 standard. Short-circuit current rating for the machine is
6 kA.

2.4 Ventilation requirements

A ventilation hood measuring at least 1200x1200mm must be provided above the machine, with a
minimum capacity of 2500 cu.m/h.
DANGER
5