Page 1
INSTALLATION AND OPERATION MANUAL P.O. BOX 557 204 INDUSTRIAL PARK DRIVE LAKEFIELD, MINNESOTA USA 56150-0577 Osseo E-Series Wall Recessed or Wall Mounted Electric Linear Fireplace Model #OSO-e50 Model #OSO-e64 Model #OSO-e80 WARNING Read and understand the entire installation and operation manual, including all safety information, before plugging in or using this product.
Page 2
Hussong Mfg. Co, Inc. Rev. 2 - Sept. 2023 Osseo E-Series Electric Fireplace Starting Serial Number: 23 OSE5000001 28, 23 OSE6400001 28, 23 OSE8000001 28...
CONGRATULATIONS! We welcome you as a new owner of a Kozy Heat electric fireplace. Kozy Heat products are designed with superior components and materials, and assembled by trained craftsmen who take pride in their work. Our commitment to quality and customer satisfaction has remained the same for over 40 years. We offer a complete line of gas, wood, and electric fireplaces, along with stylish accessories to complement any decor.
Page 4
Hussong Mfg. Co, Inc. Rev. 2 - Sept. 2023 Osseo E-Series Electric Fireplace Starting Serial Number: 23 OSE5000001 28, 23 OSE6400001 28, 23 OSE8000001 28...
4. Do not operate any heater after it malfunctions. Disconnect power at service panel and have heater inspected by an author- ized Kozy Heat dealer before reusing. 5. Do not use outdoors. 6. To disconnect the heater, turn the controls to OFF, and turn off the power to the heater circuit at the main disconnect panel.
1.0 Introduction 1.1 Appliance Certification 1.5 Parts and Hardware Laboratory: Intertek Testing Services IMPORTANT: Keep any plastic packaging and small parts away from young children as they can pose a danger. Standards: Package Contents: CSA C22.2 No 46-13 Ed.9 Electric Air-Heaters (R2018) •...
2.0 Assembly and Installation 2.1 Installation Planning NOTE: Follow all national and local building and electrical codes. • To reduce the risk of fire, do not store or use gasoline or other flammable vapors and liquids in the vicinity of the heater. •...
2.3 Appliance Preparation for Installation 2.3.1 Standard Installation Remove the screws that secure the cover plate on the side of the appliance. These screws secure the cover plate and the finishing trim. Remove and discard the finishing trim. Reinstall the cover plate and screws. Complete on both sides of appliance. This allows your framing to be flush with the body of the appliance so finishing material butts up against the 1/2”...
2.4 Clearance to Combustibles Table 2.1, Minimum Clearances to Combustibles Bottom of appliance 0” (0 mm) Left and right sides of appliance 0” (0 mm) Back of appliance 0” (0 mm) Top of appliance 0” (0 mm) Top finishing edge to 12” (305mm) mantel 0”...
2.5 Framed Appliance Opening Select a location not prone to moisture and is located at least 36” (914mm) away from the front of the appliance to combustible materials such as curtains, drapes, furniture, bedding, paper, etc. 1. Create a rough opening specific to your type of installation (Single Sided Installation, Corner Installation, 3-Sided Pier Installation) See Figure 2.1 thru Figure 2.3 for the dimensions.
2.6 Nailing Flange Installation The nailing flanges come attached to the appliance. There are (2) nailing flanges on the top of the appliance and (2) nailing flanges along the bottom of the appliance. Fold out the nailing flange as shown in Figure 2.5. Use the nailing flange to secure the appliance to framing. Figure 2.4 - Nailing Flange Location Figure 2.5 - Unfolding Nailing Flanges Hussong Mfg.
2.7 1-Piece Rectangle Surround Installation and Removal The rectangle surround is an optional accessory for the Osseo e50, e64, and e80. • This surround can only be installed when the appliance is installed in a recessed single sided installation. • This surround is recommended when you have an unfinished or exposed edge of drywall, tile, or wood.
Page 18
Install the magnetic hanging brackets as shown using the supplied screws. These brackets are adjustable to accommodate your finishing material. See Figure 2.8. Install the rectangle surround by hanging the top of the surround on the magnetic hanging brackets as shown in Figure 2.9.
2.8 4-Piece Finishing Trim Installation The finishing trim is an optional accessory for the Osseo e50, e64, and e80. • This surround can only be installed when the appliance is installed in a recessed single sided installation. • This surround is recommended when you are finishing the appliance in a smooth wall finish or are using very thin finish- ing materials.
2.9 Power Cord Outer Shell Termination This section will provide information regarding how to change where the power cord terminates the outer shell of the fire- place. The location of where the power cord leaves the outer shell of the fireplace may need to be changed depending on your installation method.
2.10 Electrical Outlet Location NOTE: Follow all national and local building and electrical codes. NOTE: If you are installing the fireplace in a recessed installation application you will have to use the supplied electrical hard-wire kit. Follow the instructions supplied with the kit. •...
3.0 Facing and Finishing 3.1 Mantel Requirements WARNING: All minimum clearances to combustible material MUST be maintained. • Combustible Mantel Projections: Mantel projections must fall within the 12” (305mm) combustible Wall Projection shown in Figure 3.1. The combined wall projection, finishing material, and combustible mantel cannot exceed a 12”...
3.2 Finishing Material Information • This appliance has a finishing trim that is designed to cover the edge of finishing material up to 1/2” (13mm) thick. • If your finishing material is thicker than 1/2” (13mm) then some of the finishing material’s edge will be exposed •...
Page 25
Figure 3.3 - Finishing Material on Corner Installation Figure 3.4 - Finishing Material on 3-Sided (Bay) Installation Hussong Mfg. Co, Inc. Rev. 2 - Sept. 2023 Osseo E-Series Electric Fireplace Starting Serial Number: 23 OSE5000001 28, 23 OSE6400001 28, 23 OSE8000001 28...
3.3 Wall Mount Installation • This fireplace is supplied with the required bracket to hang the appliance on a wall. • To mount the fireplace on a wall, you MUST secure the wall mount bracket (provided) into wood framing or another secured platform.
Page 27
Figure 3.6 - Mounting Wall Mount Bracket Figure 3.7 - Mounting Appliance on Bracket Hussong Mfg. Co, Inc. Rev. 2 - Sept. 2023 Osseo E-Series Electric Fireplace Starting Serial Number: 23 OSE5000001 28, 23 OSE6400001 28, 23 OSE8000001 28...
3.4 Floating Mantel Kit Note: The Floating Mantel Kit is an optional accessory (not included). The Floating Mantel Kit is available for the Osseo e50 and Osseo e64 models. See part# OSE50-FMK-W, OSE50-FMK-G, OSE64-FMK-W, and OSE64-FMK-G. • The Floating Mantel Kit is a great option to finish your electric fireplace when the appliance is wall mounted. 3.4.1 Floating Mantel Kit Dimensions •...
Page 29
3.4.2 Installation of Floating Mantel Kit Remove the 3 screws on each side of the appliance. Install the supplied brackets from the Floating Mantel Kit as shown in Figure 3.10 . The brackets are right and left side specific.
Page 31
Figure 3.11 - Attach the Side Sections to the Top Section Figure 3.12 - Install Top Assembly to Base Section Hussong Mfg. Co, Inc. Rev. 2 - Sept. 2023 Osseo E-Series Electric Fireplace Starting Serial Number: 23 OSE5000001 28, 23 OSE6400001 28, 23 OSE8000001 28...
Page 32
Figure 3.13 - Secure Bottom Section into Brackets and Additional Location for Screws Hussong Mfg. Co, Inc. Rev. 2 - Sept. 2023 Osseo E-Series Electric Fireplace Starting Serial Number: 23 OSE5000001 28, 23 OSE6400001 28, 23 OSE8000001 28...
4.0 Appliance Setup 4.1 Glass Front Removal and Installation 1. Remove the front trim, if installed. See Section 2.7 Front Trim Removal and Installation. 2. With one hand on the glass front to prevent it from falling, remove the screws and brackets from the top right and left of the glass.
4.3 Log Set Installation The Osseo E-Series has an optional traditional log or birch log set. Some logs may not be used in the Osseo e50 and e64 installations. 4.3.1 Osseo e50 Birch Log Set • The images below show the suggested log configuration for optional birch log set •...
Page 35
4.3.2 Osseo e50 Traditional Log Set • The images below show the suggested log configuration for optional traditional log set. • Figure 4.4 shows the (4) charred logs installed. These are positioned in front of the pulsating ember bed LEDs. •...
Page 36
4.3.3 Osseo e64 Birch Log Set • The images below show the suggested log configuration for optional birch log set. • Figure 4.6 shows the (4) charred logs installed. These are positioned in front of the pulsating ember bed LEDs. •...
Page 37
4.3.4 Osseo e64 Traditional Log Set • The images below show the suggested log configuration for optional traditional log set. • Figure 4.8 shows the (4) charred logs installed. These are positioned in front of the pulsating ember bed LEDs. •...
Page 38
4.3.5 Osseo e80 Birch Log Set • The images below show the suggested log configuration for optional birch log set. • Figure 4.10 shows the (4) charred logs installed. These are positioned in front of the pulsating ember bed LEDs. •...
Page 39
4.3.6 Osseo e80 Traditional Log Set • The images below show the suggested log configuration for optional traditional log set. • Figure 4.12 shows the (4) charred logs installed. These are positioned in front of the pulsating ember bed LEDs. •...
5.0 Operating Instructions 5.1 Methods of Operation WARNING: Read and understand this entire installation and operation manual, including all safety information, before plug- ging in or using this product. This appliance must be properly installed before use. Failure to do so could result in electric shock, fire, serious injury, or loss of life.
5.3 Appliance Control Panel Operation Note: Each time you press a button on the control panel you will hear an audible beep sound indicating an action has happened. Main Power Switch • Push the main power switch to I, the main power indicator will illuminate. Manual Switch •...
5.4 Remote Control Operation Figure 5.3 - Remote Control Note: The remote will go into safe mode after 60 seconds of not being used. Press the “power” button on the remote to unlock the remote before use. When you press the “power” button to unlock the remote the remote screen backlight will turn on. •...
Page 43
Turning on / off the appliance. Note: The rocker switch on the appliance control panel must be turned on. • Press the “power” button on the remote control to turn the fireplace on or off. Remember that if the remote has not been used within the last 60 seconds then you will have to push the power button once to unlock the remote then press the power button a second time to turn the fireplace on or off.
Page 44
Flame Effect Icon Down Light Icon Fuel Bed Effect Icon Figure 5.6 - LED Light Effect Icons Flame Effect • Press the “flame” button and the icon will flash on the remote. The flame adjustment is now active. • Press the “up” or “down” button to adjust the flame brightness. There are 5 settings which modulate the flame appearance from full flame to no flame.
6.0 Maintenance 6.1 Cleaning the Appliance The appliance should always have power turned off when performing maintenance. Go to the appliance control panel and en- sure the toggle switch is in the off position. • Carefully clean the air inlet and heater area with a cloth or vacuum on a regular basis. It is important that these areas are kept free from dust / pet hairs, etc.
7.0 Replacement Parts List Replacement parts are available through your local dealer. Contact your local dealer for availability and pricing. The following warning is for replacement parts for this appliance. ⚠ WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. P.O. BOX 557 204 INDUSTRIAL PARK DRIVE LAKEFIELD, MINNESOTA USA 56150-0577 Osseo e50 Electric Fireplace - Replacement Parts Front Viewing Glass...
Page 47
Osseo e80 Rectangle Surround OSE80-RS Osseo e64 Floating Mantel Kit - Grey OSE64-FMK-G Osseo e50 Exterior Trim OSE50-EXT Osseo E Series Traditional Log Set OSE-TLS Osseo e64 Exterior Trim OSE64-EXT Osseo E Series Birch Log Set OSE-BLS Osseo e80 Exterior Trim OSE80-EXT Hussong Mfg.
Kozy Heat authorized dealer performed by a non-authorized service provider, or distributor. A list of Kozy Heat authorized dealers is without pre-authorization. available on the Kozy Heat website (www.kozyheat.com).