Table of Contents
Advertisement
2.9 Power Cord Outer Shell Termination
This section will provide information regarding how to change where the power cord terminates the outer shell of the fire-
place. The location of where the power cord leaves the outer shell of the fireplace may need to be changed depending on
your installation method.
•
If you are installing the Floating Mantel Kit you will need to ensure the power cord terminates the outer shell of the fire-
place out the side of the fireplace as shown in Figure 2.14.
To adjust power cord termination:
Remove the (4) screws that secure the plate that secures the power cord. See Figure 2.13.
Slide the power cord out of the slot that it is currently in and remove the grommet.
Place the grommet and power cord in your new desired termination location. See Figure 2.14.
Reinstall the previously removed plate and (4) screws.
Figure 2.13 - Power Cord Cover Plate
Hussong Mfg. Co, Inc.
Osseo E-Series Electric Fireplace
Figure 2.14 - Power Cord Slot
21
Starting Serial Number: 23 OSE5000001 28,
Rev. 2 - Sept. 2023
23 OSE6400001 28, 23 OSE8000001 28
Advertisement
Table of Contents
