Ethernet I/O Modules
3.2
Configuring the Operating Mode
All tET/tPET series modules feature two operating modes, which can be selected by adjusting the
switch on the module. Note that it is necessary to
operating mode.
Run
Init
Init Mode
The Init Mode should be chosen when updating the firmware or conducting troubleshooting.
In this mode, the configurations of the module will be forced to the default factory settings.
Run Mode
The Run Mode is the default operating mode and should be used in most cases.
Note
1. After updating the firmware, be sure to set the switch back to the "Run" position and
reboot the module.
2. If the user cannot log in to the module's web server or forget the password, please refer to
Appendix A
to restore the factory default settings.
ICP DAS CO., LTD.
reboot the module
tET/tPET IO Series User Manual, Ver. 2.4, Sep. 2023, P23
after modifying the
Init
Run