Table of Contents
Advertisement
Installation
Prime Proprietary
CONTROL
PANEL
NOTE #1
JS)
MAINFRAME
[22
PDU
NOTE #2
FIRST
MM
PERIPHERAL
43
PDU
NOTE #2
SECOND
PERIPHERAL
NOTE #2
THIRD
PERIPHERAL
PDU
NOTES:
(1) ORANGE-COLORED, TWO-WIRE LINE
(2) ORANGE/WHITE COLORED, TWO-WIRE LINE
CSD-573
FIGURE 2-24:
PDU TO PDU INTERCONNECTIONS SINGLE CABINET PROCESSOR
2.8.8.2 FCC Cabinet PDU Cabling
To properly cable the Power Distribution Unit (PDU) in an FCC
cabinet
follow the steps below.
ze
Open the side and rear doors of the cabinet.
2.
Locate the main power cable on the PDU.
(Note that the PDU
power
cable
has been inserted through a cable cover port, MEC6658-002.)
Perform either step 3a or 3b depending on whether the facility has
a raised
or
solid
floor.
Refer
to
Figure
2-26
for
either
procedure.
3a. RAISED FLOOR:
Facing the side of the cabinet,
locate
the
cable
cover
port (P/N MEC6085-001) on the bottom corner frame inside of
the cabinet.
This port is
referenced
as
"A"
in
Figure
2-26.
Remove and discard the port.
Also remove the smaller cable access panel, "B"
in
Figure
2-26,
located to the immediate right of the cable cover port.
070-C
2-
44
Advertisement
Table of Contents
