Table of Contents
Advertisement
Installation
Prime Proprietary
TYPICAL SECTION
OF PRINTED
CIRCUIT BOARD
COLOR
CODES
ON BOARD
STIFFENER
MAINFRAME
CONTROLLER
ATTACHING
SCREWS
RECEPTACLE-END
OF TYPICAL CABLE
100-A
PRIMARY POWER
CORD & TWIST-LOCK
CONNECTOR
~~ POWER CORD-PLUG
FOR POWER SUPPLY
CSD-566
FIGURE 2-17:
TYPICAL CABLE CONNECTIONS AT MAINFRAME CABINET
2.8.5.2 I/O Cabling For FCC Cabinets
The following are basic bulkhead I/O cabling guidelines.
1
ae
2.
Reseat the circuit boards in the backplane before
connecting
any
cables,
Mate the
receptacle-connector
end
of
each
cable
with
its
respective
color-coded
edge
connector
on
the
board
in
the
backplane.
Tighten the receptacle-connector screws on each
mated
connector.
:
Connect cables to the lowest board in the cabinet first, then work
up.
This saves time adjusting cables as new ones
are
installed.
Mate the bulkhead connector end of each cable with the appropriate
opening in the bulkhead (Figure 2-18) and tighten
the
screws
on
each mated connector.
070-C
2-
32
Advertisement
Table of Contents
