Table of Contents
Advertisement
Operating Instructions
10.
B)
Then type the command line:
OK, LOGOUT -<YTSMAN's user number>
Phantom nn:
Normal logout at hh:mm
Time used:
xxh xxm connect, xxm xxs CPU, xxm xxs I/O
Send a final warning to all users:
Nee
OK, MESSAGE ALL-NOW
SYSTEM GOING BOWN.
PLEASE LOGOUT. (Control G)
Log out all users with the command line:
OK, LOGOUT ALL
verify that all users and subsystems have been logged out by using
the command, STATUS ALL.
Shut down the system by using the command:
OK, SHUTDN ALL
REALLY?
YES
WAIT,
~~
PRIMOS NOT IN OPERATION
DPM400:
CPU HALTED AT 000006/003525:
003776
After completing the operating system shut-down procedure, remove
the
system's power as described in the section, REMOVING SYSTEM POWER.
3.4.1.2 PRIMOS II Shut—down Procedure
To shut-down PRIMOS II, use the command:
OK:
SHUTDN
OKs
This
command
does
not
halt the CPU, however it is 'shut down'.
To
halt the CPU, press the MASTER
CLEAR
button
on
the
system
status
panel.
Then
remove
the
system power as described in the following
section.
3.4.2 REMOVING SYSTEM POWER
Remove power from the system's
equipment
in
the
reverse
order
of
system startup:
e
Line printers
e@
Modems
s
.
od
@
Magnetic tape drives
e
Disk drives
®
System CPU
070-C
3~-
10
Advertisement
Table of Contents
