CAME LVC/01 Programming Manual page 9

Reprogramming
PROG PROG
>3''
1 1
1 P.E
beep beep
1
2 2
beep beep
3 3
beep beep
beep beep
4
PROG PROG
<1''
5 5
PROG PROG
>3''
6 6
1 P.E
1
G G
Going into Programming
Press the PROG key on the power supply A until the PROG LED lights up. The
PROG LED and key back lighting will fl ash 2. Wait 5 seconds for the auto test
M
to be completed and continue as shown below.
2 P.E
Programming call keys
Press the door release
panel, press the call key to be linked to the receiver 4: a beep will confi rm that
the setting has been stored.
Exiting Programming
Briefl y press the PROG button. The PROG LED switches off .
☞
If no action is performed, the procedure will end automatically after 30
M
minutes.
Programming Type of Keys
In "Programming Call Keys" A press and hold down the PROG key on the power
supply 6 until you go into the "Programming Type of Keys" procedure G.
M
2 P.E
and AUX2 buttons at the same time 3. On the entry
Continue, repeating the same operations for all the other
receivers. The operation may only be carried out from the
entry panel with the active beep signal (PE1 in fi g. 2): to
change the entry panel from which the call programming
is carried out, press one of the call keys for at least 3
seconds.