Advertisement
First Programming with several entry panels
PROG
PROG
>3''
A A
1 P.E
1
2
2
1 P.E
1
3 3
6 6
beep
beep
G
PROG
PROG
<1''
8 8
Going into Programming
Press the PROG button on the power supply 1 until the PROG LED lights up.
If the PROG LED immediately goes out, this indicates a malfunction in the
M
connections between the power supply and the entry panel. Check the
connections and return to programming.
The PROG LED and key back lighting will fl ash as shown in fi gure 2. Wait 5
seconds for the auto test to be completed and continue as shown below.
2 P.E
Programming Type of Keys
Press the fi rst key on the entry panel in the position shown 3 until the back
lighting LEDs stop fl ashing. Repeat this operation for all the entry panels to be
programmed 4: at the end the signals will have this confi guration E. A beep
sounds to signal that you have entered "Programming call keys".
2 P.E
1 P.E
1
4 4
Programming call keys
Press the door release
On the entry panel, press the call key to be linked to the receiver 7: a beep
will confi rm that the setting has been stored. Continue, repeating the same
operations for all the other receivers.
Exiting Programming
Briefl y press the PROG button. The PROG LED switches off .
☞
If no action is performed, the procedure will end automatically after 30
M
minutes.
2 P.E
beep
beep
1
E E
and AUX2 buttons at the same time 6.
The operation may only be carried out from the entry panel
with the active beep signal (PE1 in fi g. E): to change the
entry panel from which the call programming is carried
out, press one of the call keys for at least 3 seconds.
1 P.E
2 P.E
Advertisement
