CAME LVC/01 Programming Manual page 5

Reprogramming
PROG
M2
M2
SW3
1 1
2 2
BOUT
beep beep
4
PROG
M2
M2
SW3
E
PROG
M2
M2
SW3
F F
G G
BOUT
M1
8 8
BOUT
Going into Programming
PROG >3'' >3''
Press the PROG key for at least 3 seconds 1 and then release it (within 6
<6'' <6''
seconds) as soon as the PROG LED fl ashes and the key back lighting lights up
as illustrated in fi gure 2.
SW3
P PROG
C C
Continue, repeating the same operations for all the other receivers.
PROG
<1'' <1''
Exiting Programming
Press the PROG button briefl y E. The PROG LED switches off .
☞
If no action is performed, the procedure will end automatically after 30
SW3
minutes.
Programming Type of Keys
In "Programming Call Keys", press the PROG key for at least 3 seconds F and
PROG >3'' >3''
then release it (within 6 seconds) as soon as the PROG LED lights up and the
<6'' <6''
key back lighting fl ashes as illustrated in fi gure G, entering "Programming
Type of Keys".
SW3
Press the fi rst key on the entry panel in the position shown 8 until the back
lighting LEDs stop fl ashing I and stay on.
At the end, to exit programming, briefl y press the PROG key E: the PROG LED
switches off .
If no action is performed, the procedure will end automatically after 30 minutes.
PROG P
M1
9 9
BOUT
Programming call keys
Press the door release
same time.
On the entry panel, press the call key to be linked to the
receiver 4: a beep will confi rm that the setting has been
stored.
and AUX2 buttons C at the