Advertisement
PROGRAMMING ENTRY PANELS WITH VA/01
First Programming with one entry panel
PROG
PROG
>3''
1
M1
2 2
BOUT
M1
3
3
BOUT
M1
4 4
BOUT
E E
beep
beep
F F
PROG
PROG
<1''
G
Going into Programming
Press the PROG button on the power supply 1 until the PROG LED lights
up. Failure of the PROG LED to light up, indicates a malfunction. Check the
M
connections and return to programming. The PROG LED and key back lighting
will fl ash 2.
Wait 5 seconds for the auto test to be completed and continue as shown below.
Programming Type of Keys
Press the fi rst key on the entry panel in the position shown 3/3A3B until the
back lighting LEDs stop fl ashing 4 and stay on. A beep sounds to signal that
you have entered "Programming call keys".
M1
A
3 3
BOUT
Programming call keys
Press the door release
beep
beep
panel, press the call key to be linked to the receiver 6: a beep will confi rm that
the setting has been stored.
Continue, repeating the same operations for all the other receivers.
Exiting Programming
Briefl y press the PROG button on the power supply G. The PROG LED switches
off and the entry panel stops ringing.
☞
If no action is performed, the procedure will end automatically after 30
minutes.
M
M1
B
3 3
BOUT
and AUX2 buttons at the same time 5. On the entry
Advertisement
