What to do in the event of malfunctions
Troubleshooting
For your safety
Faults in the system
Fault
No function at all.
Page 132
•
Many malfunctions are detected automatically. Therefore, pay attention
to the error messages displayed on the 5.7" control panel (see Page 135).
•
If there is a failure and you cannot resolve the issue using information in
the chapter "What to do in the event of malfunctions", attach a sign "Out
of order" to the system and contact a ZEISS service representative.
Possible reason
Power plug of stand not
inserted.
Power switch of stand not
switched on.
Automatic circuit breaker in
the stand power switch is
being triggered.
Power failure.
Corrective measure
Plug in the power plug.
Press power switch. Green
indicator light in the power
switch must be lit.
Press power switch again.
Contact in-house electrician.
OPMI Lumera i
Cross
reference
Page 76
Page 91
Page 91
-
Version 8.0
G-30-1720-en