Setting Parameters For Total Magnification; System Information; Pairing With Wireless Foot Control Panel - Zeiss OPMI Lumera i Instructions For Use Manual

Operation

Setting parameters for total magnification

System information

Pairing with wireless foot control panel

NOTE
Page 124
To ensure correct display of the total magnification, the parameters of the
objective lens, tube, and eyepieces used must be set. The settings are applied
for all users.
• Select <System Settings><System Options><Optical Settings> in the main
menu.
 The "Optical Settings" menu is displayed.
• Select the system components used in the "Objective", "Tube", and "Eyepieces"
fields.
• To save the changes, press the
 The "System Options" menu is displayed again.
The "Version" submenu permits you to check the software currently installed
in your system.
• Select <System Settings><System Options><Version> in the main menu.
 The "Version" menu is displayed.
 It contains information on the currently installed PC software (PC-SW)
and firmware (Light, Opmi, XY, Camera, Gateway, Foot Panel).
Pairing is the term used to describe the fixed relative assignment of the suspension
system and foot control panel. Pairing must be performed for wireless operation.
The foot control panel may be disabled
• If pairing is performed incorrectly or not at all, the foot control panel may
be disabled or activation of a control may trigger functions on a different
suspension system not assigned to the foot control panel.
OPMI Lumera i
button.
Version 8.0
G-30-1720-en