Table of Contents
Advertisement
3 EyeCAN USB Cable
3.1 Power
The EyeCAN is powered through the USB connector. The host must supply 5V DC, as per USB specification.
3.2 LEDs
The EyeCAN has four LEDs. Their functions are shown in Table 1.
LED
ERR
PWR
LED 1
LED 2
Table 1: EyeCAN LED configuration.
3.3 USB Connector
The EyeCAN may be connected to any free USB socket on the host computer.
Power does not have to be turned off before inserting or removing the device.
It is good practice, though, to exit all applications using the CAN hardware before removing the EyeCAN.
The USB cable included with the delivery is approx. 140 centimeters long and is permanently attached
to the EyeCAN.
If a longer cable is desired, use a standard extension cable with a type [A] receptacle (Figure 4) at one
end and a type [A] plug (Figure 5) at the other end.
Do not extend the cable to more than 5 meters without an active extender.
With an active extender, the maximum length is 25 meters.
Figure 4: USB Type "A" Receptacle
Mobileye EyeCAN Kit
User Guide
v3.1
LED Color
Function
Red
ERR
Green
Power
Blue
CAN Tx
Yellow
CAN Rx
Description
Active when the EyeCAN is powered
Active when a CAN message is sent
from EyeCAN to CAN bus
Active when a bulk of CAN messages
are sent from EyeCAN to USB bus
Figure 5: USB Type "A" Plug
4
Advertisement
Table of Contents
