Additional Information - Banner SureCross DX80 Manual

Terminal Block (IP20 Housing)
Connecting dc power to the communication pins will cause permanent damage. Do not exceed analog input ratings for analog inputs.
Only connect sensor outputs to analog inputs.
AI1
AI2
AI3
AI4
V−
V−
V+
V−
V−
Wiring Diagrams for Analog Inputs
Connecting dc power to the communication pins will cause permanent damage. Do not exceed analog input ratings for analog inputs.
Only connect sensor outputs to analog inputs.
Analog Input Wiring (10 to 30V dc Pow-
er)
SureCross Device
Wiring Diagrams for Analog Outputs
Connecting dc power to the communication pins will cause permanent damage. Do not exceed analog input ratings for analog inputs.
Only connect sensor outputs to analog inputs.
Analog Output Wiring
SureCross Device
AOx
GND
PWR

Additional Information

For additional information, including installation and setup, weatherproofing, device menu maps, troubleshooting, and a list of accesso-
ries, refer to one of the following product manuals
• SureCross Quick Start Guide: Banner part number
• SureCross Wireless I/O Network Manual:
• Web Configurator Manual (used with "Pro" and DX83 models):
4
AO1
AO2
AO3
AO4
V+
V+
TX/+
RX/−
V+
Analog Input Wiring (Externally Powered
Sensors)
AIx
external
power
dc common
PWR
128185
132607
www.bannerengineering.com - tel: 763-544-3164
AIx or Ax. Analog IN x.
AOx. Analog OUT x.
CMx. Not used. Do not make any wiring connections to these ter-
minals.
RX/-. Serial comms line
TX/+. Serial comms line
V+. Power, 10 to 30V dc power connection.
V-. Ground/dc common connection.
Analog Input Wiring (Switch Powered
Sensors)
SureCross Device
AIx or Ax+
GND
(Only possible in models with switch power
(SPx) outputs)
134421
SureCross DX80 Gateway with Analog I/O
SureCross Device
AIx or A x+
SPx
P/N 134302 rev. G