Usb Output - Projecta IS2000 Instruction Manual

USB OUTPUT

The USB output allows the user to charge external compatible devices.
Step Detail
1 If the IS2000 is not in jump starting operation, and the user connects an external
device to charge the following screen will be displayed.
Note: The USB output will be automatically disabled in the following conditions:
• IS2000 is turned off
• Once USB device is fully charged
• Exit mode
• Jump start mode
• Error mode
• Rapid Recharge (RRT
• Low battery condition
• Battery temperature below -20°C or above 60°C, or ambient temperate above 45°C
CHARGING
Step Detail
1 Plug the output of the AC charging dock into a 240V AC socket. Once
the AC dock is plugged into a 240V AC source, you can place the
IS2000 onto the charging dock. Alternatively, plug a USB-C cable into
the USB-C port on the IS2000 to begin charging the jump starter.
**Using a non-supplied charger and USB cable may extend
charge time.**
2 The battery charging screen will be shown when the IS2000 is
being charged either by the 240V AC dock or USB-C socket plugged
in.
3 When the IS2000 is fully charged, it will display "CHARGING
COMPLETE".
4 The IS2000 will display the "CHARGER TIMEOUT" screen if the
charging cycle cannot be completed in 24 hours. The typical charging
time is 4 hours if the battery is at 50% state of charge.
Note: It is recommended to fully charge the IS2000 before the first use, as the IS2000 is shipped only
partially charged.
) mode
®
Display
Display
CHARGING
COMPLETE
9