Display Character Table - CLEAN Instruments PH200 Operation Manual

7.3.7 P07 Reverting to Factory Default Setting
In P-07, you can select NO or YES to not reverting or reverting to factory settings by pressing
Please refer to above description steps to set up P-07.
If select YES, the meter will revert all the settings to factory defaults and all the settings will lost
forever. The unit will restart at the same time.
You can go to next parameter setting by pressing
back to measurement mode.
Note:
1. During setting, you can press key to quit setting whenever necessary.
2. During setting, you can adjust anything twinkling by pressing
twinkling, you can speedy adjust the data by pressing
36
.
, or pressing key to quit and go
. If it is the data
.

4.2 Display Character Table

Sensor
Automatic Temperature Compensation
Manual Temperature Compensation
Automatic Temperature Compensation
Manual Temperature Compensation
Electrode Slope
autolock
Auto Off
no stored data
Clear data
place of the stored data
Sensor Offset
Menu item
Buffer Solution
NIST Standard
USA Standard
TDS
Salinity
Temperature Base
Coefficient
Offset
Password Setting
Factory Defaults
Sensor Slope 1
Sensor Slope 2
Save Data
Error
On
Off
No
Yes
Temperature value Over
Temperature value Under
Full Data Storage
Measuring Value Over
Measuring Value Under
nA output of electrode
Sensor slope
Atmospheric pressure
Salinity
%
mg/L
DO electrode voltage
05