7.6.3 Setting parameter
1. Long press
to enter into Setting parameter when in measurement mode. Press
check through all the parameters.
2. Press
to quit and go back to measurement mode.
40
1 Preface
1.1 Before Use
Thank you for selecting CLEAN meter.
Although the meter use advanced technology and meet
the requirements of current safety rules, improper use can still threaten the safety of users, and / or
cause harmful influences to factory and other equipments. Therefore, before using the
meter, relevant person must read and understand contents of this operation manual.
Operation manual should be kept accessible within the person who use the meter.
If you have problems which are not mentioned or can not be explained in this manual, please
contact CLEAN local customer service center. They will be very glad to help you.
1.2 In Use
to
On any unmentioned use or the use that contradict with the technical parameters the operators
should bear the responsibility.
Other conditions of right use include:
- Remarks and requirements stated in operation manual.
- Local safety regulations on safe operation.
- Information and warning of products that are used together with the meter in the contract.
(chassis, electrode, etc.)
- Required operating environment and working condition.
1.3 Safety
The meter may only be carried out by trained experts.
!
Unqualified meter should not be installed and used.
The meter should be used under the required working condition.
The meter should not be opened and repaired by clients themselves.
Modified meter should not be used. Manufacturers and suppliers do not bear
responsibility for the damage and lost caused by modifying instruments without
permission. Clients should bear all the risks.
This instrument is IP67 rated. Please use waterproof cable glands when you connect
the cable. Also,please loose it when you open the cover. After connecting the
cable, please tighten the cable conductor according to the following instruction
with cable ties, or it will cause danger such as cable conductor or interface falls off
when open the cover.
!
Please make sure to cut the power off when you open the cover to carry on any operation.
01
Need help?
Do you have a question about the PH200 and is the answer not in the manual?