Calibration Parameter And Setting Parameter - CLEAN Instruments PH200 Operation Manual

Ph/orp/ conductivity/ tds/ salinity/ dissolved oxygen meter
Hide thumbs Also See for PH200:
Table of Contents

Advertisement

6.3.6 P06 Auto Lock Function Setting
In P-06, you can set the Auto Lock Function.
Please refer to above description steps to setup P-06.
If the Auto Lock Function is ON, the meter can lock the measured value after the reading had
stabilized. Press
to unlock.
You can go to next parameter setting by pressing
back to measurement mode.
6.3.7 P07 Auto Power Off Setting
In P-07, you can set the Auto Power Off Function.
Please refer to above description steps to setup P-07.
If the Auto Power Off is ON, the meter will power off if no operation in 10mins.
You can go to next parameter setting by pressing
24
back to measurement mode.
,or press
key to quit and go
, or press
key to quit and go

5.7 Calibration Parameter and Setting Parameter

1. Long press
to enter into Setting parameter when in measurement mode. Press
to check through all the Calibration parameters and Setting parameter.
2. Press
to quit and go back to measurement mode.
17

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PH200 and is the answer not in the manual?

This manual is also suitable for:

Con200Do200

Table of Contents