Basic Operation; Battery; Electrode Installation; Shell - CLEAN Instruments PH200 Operation Manual

Ph/orp/ conductivity/ tds/ salinity/ dissolved oxygen meter
Hide thumbs Also See for PH200:
Table of Contents

Advertisement

2 Basic Operation

2.1 Battery

Use the coin to remove the battery cover by following the "-" direction.
Insert 2*7AAA batteries in the battery compartment with the correct Positive and Negative poles.
Tight the battery cover by following the "+" direction.
-
+

2.2 Electrode Installation

You can refer to the Electrode operation manual for use and maintenance. The direction of the red
dot marker on the Electrode and the salient point on the unit should be the same when install the
electrode to the unit. Remove the electrode by pulling out the clamp on the electrode.

2.3 Shell

This series of meter is portable and water-proof, with IP67 rated. If the meter accidentaly touches
water or other fluids, pls wipe it clean immediately. The meter function is not affected usually. But if
affected and cannot use, (possibly because of the battery cover is not tight and penetrated by
water). Please contact our company or CLEAN local customer service center. They will be very glad
to help you.

2.4 Power on/off and Backlight

Power on
Short press power on/off key to start the meter. You can hear the indicator tone and whole screen
displayed within 1 second.
Power off
Long press the power on/off key to power off the meter.
Auto power off in 10 minutes if without any operation.
LCD backlight
Short press power on/off key to control if turn on the backlight or not.
02
PH200
CON200
DO200
7.6 Storage of Data
7.6.1 Storage of measuring data
1.If you need to save the measuring data once it is stabilized, press
on the upper right of the screen. Press "
" to save the data. You can also press
save. The meter will automatically go back to measurement mode after data saved. The unit at
most can save 50 sets data. The screen will show "OVER" if more than 50 sets reminds you the
memory card is full.
2.Enter into setting mode P-06 if you need to delete the saved data forever. You can refer to
Clearing memory function.
7.6.2 Browse on data storage
1. Press
to enter into the browse on the data storage , the Lot no. will be shown and data
twinkling. Press
to check all the saved data. Press
showed "NONE" means no data is saved yet.
2. If you quit and re-entering during checking the data, the meter will freeze in the last set of data.
, the Lot no. will be shown
to not
to go back to measuring mode. If
39

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PH200 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Con200Do200

Table of Contents