5.6 Storage of Data
5.6.1. Storage of measuring data
1.If you need to save the measuring data once it is stabilized, press
on the upper right of the screen. Press
save. The meter will automatically go back to measurement mode after data saved. The unit at
most can save 50 sets data. The screen will show "OVER" if more than 50 sets reminds you the
memory card is full.
2.Enter into setting mode P-06 if you need to delete the saved data forever. You can refer to
Clearing memory function.
5.6.2. Browse on data storage
1. Press
to enter into the browse on the data storage , the Lot no. will be shown and data
twinkling. Press
to check all the saved data. Press
showed "NONE" means no data is saved yet.
2. If you quit and re-entering during checking the data, the meter will freeze in the last set of data.
16
, the Lot no. will be shown
to save the data. You can also press
to not
to go back to measuring mode. If
6.3.8 P08 Clearing Memory Function
In P-08, you can set the Clearing Memory Function.
Please refer to above description steps to setup P-08.
If select YES, the meter will clear all the saved data.
You can go to next parameter setting by pressing
back to measurement mode.
, or press
key to quit and go
25
Need help?
Do you have a question about the PH200 and is the answer not in the manual?