Technical Specifications; Browse The Parameter - CLEAN Instruments PH200 Operation Manual

Ph/orp/ conductivity/ tds/ salinity/ dissolved oxygen meter
Hide thumbs Also See for PH200:
Table of Contents

Advertisement

7.3.4 P04 Auto Lock Function Setting
In P-04, you can set the Auto Lock Function.
Please refer to above description steps to setup P-04.
If the Auto Lock Function is ON, the meter can lock the measured value after the reading had
stabilized and display
. Press
to unlock.
You can go to next parameter setting by pressing
back to measurement mode.
7.3.5 P05 Auto Power Off Setting
In P-05, you can set the Auto Power Off Function.
Please refer to above description steps to setup P-05.
If the Auto Power Off is ON, the meter will power off if no operation in 10mins.
You can go to next parameter setting by pressing
back to measurement mode.
34
, or press
key to quit and go
, or press
key to quit and go

5.1 Technical Specifications

pH
Range
-2.00
16.00 pH
Resolution
0.01 pH
Accuracy
±0.2% F.S.
ORP
Range
-2000~2000 mV
Resolution
1 mV
Accuracy
± 0.2% F.S.
Temperature
Range
-10.0 °C~110.0 °C
Resolution
0.1 °C
Accuracy
± 0.2 °C
Power
Power supply
2*7 AAA batteries
Working time
>500 hrs
pH Buffer Kinds
NIST
4.00
6.86
USA
4.01
7.00
Others
Environment
-5 °C~60 °C, Relative humidity 90%
Memory
50 sets

5.2 Browse the parameter

Long press
for 3 seconds in measurement mode.
Then press            or           to browse the parameters
1. Zero offset
2. Slope
3. High/Low segment of the slope
4. Buffer kinds
5. Temperature compensation
6. Hold Auto Lock
7. Auto power off
8. Battery power
9.18
10.01
07

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PH200 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Con200Do200

Table of Contents