Conductivity / Tds / Salinity - CLEAN Instruments PH200 Operation Manual

Ph/orp/ conductivity/ tds/ salinity/ dissolved oxygen meter
Hide thumbs Also See for PH200:
Table of Contents

Advertisement

6.3.2 P02 Temperature Compensation Base
In P-02, you can set system base value for conductivity measurement. .
Please refer to above description steps to setup P-02.
Range of Temperature Compensation Base: 15.0-35.0°C
You can go to next parameter setting by pressing
back to measurement mode.
6.3.3 P03 Conductivity Temperature Factor
In P-03, you can set Temperature coefficient for conductivity.
Please refer to above description steps to setup P-03.
Range of Conductivity Temperature Factor: 0.00-10.00%
You can go to next parameter setting by pressing
back to measurement mode.
22
, or press
key to quit and go
, or press
key to quit and go

Conductivity / TDS / Salinity

CON200 Meter
·
New design, Comfortable holding, Easy carrying , Simple Operation
·
65*40mm, large LCD with backlight for easy meter information reading
·
IP67 rated, dustproof and waterproof, Floats on water
·
Measuring range: 0.000 us/cm-400.0 ms/cm, Automatic range switching
·
Unit display: us/cm;ms/cm,TDS(mg/L), Sal((mg/L),°C
·
One key to check through all the settings, including: cell constant, slope
and all the settings
·
Auto lock function
·
50 data sets memory stores and recalls
·
Auto Power off saves battery after 10-mins non-use
·
2*1.5V 7AAA battery, long battery life
·
CP337 Operating Carrying Pouch
19

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PH200 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Con200Do200

Table of Contents