Table of Contents
Advertisement
User's Manual
Voltage,
Current,
Power,
Apparent
Power Factor
0 Input Alarm
Blinking
Alarm Delay Times
Beep
Data Hold
Mute Key
*Notes: The item cannot be restore to the factory setting: the relevant setting of communication
(communication command, baud rate, Modbus communication address).
7.2 View Software Information
7.2.1 Software Information of UTE9802+/UTE9811+
·Steps
1. Long press【ENTER】(Utility) key to enter Utility menu, press【 】 or【 】key to select submenu"Ver"
as shown in the following figure；
2. Press【 】or【 】key to select other submenu, or press【SETUP】key to exit Utility menu.
·Explanation
"
7.2.2 Software Information of UTE9806+
Steps
1. Press【Shift】and【Setup】key to enter Utility menu;
2. Press【▲】or【▼】key to select inFo；
3. Press【OK】key to enter the version interface as shown in the following figure;
Instruments.uni-trend.com
Active
OFF，the upper and lower limit is"0"
Power,
OFF
OFF
"0010"
Beep times"0005"
OFF
OFF
"represents firmware version ； "
UTE9800+ Series Smart Digital Power Meter
" represents hardware version.
44 / 55
Advertisement
Table of Contents
