UNI-T UTE9800+ Series User Manual page 37

User's Manual
9. Press 【▲】 , 【 ▼】 , 【 】 , 【 】 key to edit data and press 【Shift】 + 【Hold/·】 key can move the decimal
point from left to right.
10. Press【OK】key to finish the setting and return to the previous menu.
·5.4.2 Alarm Mode
1. Press【Shift】and【Setup】key to enter Utility menu;
2. Press【▲】or【▼】key to select ALARM;
3. Press【OK】key to enter ALARM menu，press【▲】or【▼】key to select SET；
4. Press【OK】key to enter alarm parameter menu, press【▲】or【▼】key to select DELY, OUT0, LEDF,
BEEP
5. Press【OK】key to enter the parameter setting window, press【▲】,【▼】, 【 】,【 】key to select
ON or OFF; If the previous step is selecting DELY or BEEP, then this step is to edit the numerical value as
shown in the following figure;
6. Press【OK】key to save the currently selected and return to previous menu;
7. Press【Hold】key to return to previous menu and back to the measurement interface at last.
·Explanation
Alarm function is for detecting whether the measured data is within the set range. UTE9806+ supports
alarm of U (voltage), I (current), P (active power), VA (apparent power) and PF (power factor).
Alarm Condition
1. Only set the upper limit, if the measured value is greater than the upper limit U----alarm will be
Instruments.uni-trend.com
UTE9800+ Series Smart Digital Power Meter
37 / 55