National Instruments PCI-7354 Getting Started page 12

The UMI-7772/74 DIP switch configuration is shown in Figure 4.
Figure 4. UMI-7772/74 Fault and Enable DIP Switch Settings
Note Configuring the limit and home status LEDs on the UMI-7772/74 does not
configure the limit and home inputs themselves as active-high or active-low. You
must configure the limit and home inputs separately on the National Instruments
motion controller using MAX or the NI-Motion driver software. This DIP switch
does not need to be configured when the UMI-7772/74 is used with the AKD servo
drive.
4. Connect the positive lead of the +24 V external power supply to the V terminal and the
negative lead to the C terminal, then connect the V terminal to the V
C terminal to the C
Note You may use the same +24 V power supply to power both the UMI-7772/74
and the AKD drive. However, ensure that the power supply is capable of delivering
enough current for the application. If you require more power, connect a separate
+24 V power supply to the AKD drive X1 connector as described in
the Logic Power Supply to the AKD Servo
Getting Started with NI 7340/7350 Controllers and AKD Drives | © National Instruments | 11
FAULT FWD
ACTIVE
LOW
FAULT
1
14
2
15
3
16
4
17
5
18
6
19
7
20
8
21
9
22
10
23
11
24
12
25
13
FEEDBACK
terminal.
iso
AXIS 1
DISABLED
HOME REV
ACTIVE
HIGH
ENABLE
LIMIT LED
1
9
2
10
3
11
4
12
5
13
6
14
7
15
8
CONTROL
Drive.
terminal and the
iso
Step 4: Connect